The scooter has been preserved and mounted, finally the long awaited moment scooter. The desire to keep the key in the hole, press the button and hear the hum of the engine is irresistible in the area …

But it must be resisted. Even if the above sounds ideal, is not the case. Imagine a car that was parked for six months, he may not start at the first attempt. In this case we speak have been sitting for a scooter that, in addition to 6 months or more mayhad traveled by sea for 2 or 3 weeks, love carburetor salty sea air.

This article is to develop properly the first time scooter owners, their scooter without bubbles begin to nothing.

Dos and don'ts:

1. When the roller 50 or 150 centimeters, not the e-start attempt to start the first kick until
2. Of not groped, in any event, the start-up Roller
3. Avoid using the battery charger. The engine recharges the battery ifwas started. If you use a charger to ensure that there is a charger motorcycle no more than 2 amps
4. When the scooter is equipped with an alarm, do not try to alarm or to start on the remote to start the scooter
5. Buy more expensive fuel and fill the tank up
6. Do not use any fuel additive or carburetor cleaner solution
7. Once the scooter has been started, be ready to ride for at least 15 minutes for the battery – the charge can beMotor, the battery is charged by far the best

I remember that a new battery is very fragile. If all goes to the core, can cause permanent damage and damage to other components, such as the fuse, voltage regulator and / or CDI unit. To protect the battery and other components that should initially start with 50cc and 150cc kick start, try the e-start a couple of times as described below.

Since most 250cc scooters have a beginning soccer250cc scooter owners must be at the E-start procedure.

Procedures Kick Start:

1. Fill the fuel tank with the best available
2. Place the tripod in the middle
3. Check the kill switch is directed toward the rim, not the X
4. When the scooter came with remote control, click the unlock two consecutive
5. Turn the key in position
6. Speed up the whole way and keep the gas from 1 second, repeat 3Viewed
7. Fold the kick-start, push it gently with his foot midway
8. Let the kick starter again
9. Kick football starter vigorously 3 or 4 times in a row that the starter goes to the bottom and goes all the way back, every time
10. Then he keeps on speeding up the whole way (step 6) and kicked all the way home a couple of times (Step 9)
11. Access all your gas, while kicking

Try the E-start only after they tried to spin the wheel, as described above to startwith the kick-start.

Procedures Electric start:

1. Follow steps 1 to 6 of instituting proceedings for
2. Hold the rear brake
3. Turn the throttle to raise the springs, not accelerate, hold the slack
4. Press the Start button for 3 seconds and release
5. Accelerate all the way and let go to keep up any slack in the gas
6. Press the Start button for 3 seconds and release
7. And let the engine starts let cool again for 30 or 40 seconds andthe steps above again.

Overheating can also start the electric motor also damage the scooter blowing starter, backup and other electrical parts.

If the car is not started, do not search your e-start procedure more than 2 times but return to football to start a procedure and repeat 2 or 3 times. It may take several attempts to start most of the bike in 2 or 3 to try.

If all this fails, the others:

Some of my scooter it difficult to leave. This can beseveral factors. In 90% of cases, the failure must be started because no or inadequate tank almost to the carburetor. The easiest way to treat them, is the first carburetor manually:

1. Open Seat
2. Loosen the screw of the carburetor access panel (typically a single screw)
3. Remove the cover and locate the carburetor
4. The top of the carb looks like a dome of metal with 2 screws that secure the
5. Remove the 2 screws from the top of the carburetor
6.Put 3-4 tablespoons of gasoline directly into the carburetor
7. Replace the top of the carburetor and secure with 2 screws
8. Follow the E-start the process only if it is not more than 3 times, otherwise kick-start, followed

If the bike does not start up, are those with little mechanical knowledge, and who knows enough to be dangerous requested the technical support department of the store where the contact scooter purchaseconstructed or are you looking for a professional bike mechanic.